CANVAS Re-Amp

Adding another tool to the musical paint pallet, Walrus Audio is creating another way to design your tonewith the Canvas Passive Re-Amp. The Re-Amp is a studio tool designed to send recorded guitar, drums, or other instrument tracks from your recording session through pedals and effects, or different amp combinations. The Re-Amp makes it’s appearance to facilitate all-new ways to experiment with your songs.
Artists and producers can save time on tracking sessions by recording dry tracks first, then using Canvas Re- Amp’s custom transformer to convert line-level signals, optimizing them to work with amps and guitar pedals of any kind to explore limitless tones and sounds.

Passive Studio Re-Amp box
Send previously recorded tracks through guitar pedals or different amp combinations.
Record your dry tracks first then re-amp later.
Try pedal- or amp-combinations on dry guitar tracks, drums, vocals or other instruments.
Explore new ways to experiment with your songs.
Rediscover the joy and creativeness of using outboard gear during your DAW sessions.
Flat frequency response from 20 Hz to 20 kHz
Custom wound transformer that converts the impedance of your signal to work with guitar pedals and amplifiers.
Converts 1⁄4” balanced or XLR input from your DAW/Interface to unbalanced 1⁄4” output to pedals or amps.
Volume knob to control the level of the re-amp signal being sent back into your pedalboard/amp.
Ground lift for reducing hum if present on XLR input.
Phase Inversion switch for phase cancellation when needed.
High-pass filter to reduce low frequency when needed.
Passive design, no power-supply required
Pedalboard-friendly format
Designed and assembled in USA.